burning temperature
英 [ˈbɜːnɪŋ ˈtemprətʃə(r)]
美 [ˈbɜːrnɪŋ ˈtemprətʃər]
网络 燃点
双语例句
- Because the dividing line between pottery and porcelain, care about quality white hard or semi-transparent, and the largest is the key to burning temperature.
因为陶与瓷的分野，在乎质白坚硬或半透明，而最大的关键在于火烧温度。 - According to different uses, we can burn low-temperature carbon, or charcoal burning temperature.
根据不同用途，我们可烧低、中温炭，也可烧高温炭。 - The influence of the burning temperature and the time required for maintaining the temperature on the dissolution properties of various burnt gypsums is discussed and presented in this article.
在硅酸盐水泥中，应用经过煅烧的石膏比二水石膏更能提高水泥的强度。为此，研究和分析了煅烧温度、保温时间对煅烧后的二水石膏在纯水中的溶解特性的影响。 - Determination and Calculation of the Burning Temperature for DJ-6B Primer Compositions
底-6乙底火药剂的燃烧温度测定与计算 - The increase of burning temperature causes the copper extraction into solution up to98%, while copper extraction into solution from non-burned samples was up to6%.
升高的温度导致溶液中铜的萃取物高达98%，而在没燃烧样品的铜的萃取物到达6%。 - Study on optimum burning temperature of white cement by soda residue
碱渣烧制白色水泥适宜煅烧温度的研究 - The increase of the burning temperature caused the lowering of the copper extraction.
升高的燃烧温度导致了降低的萃取铜含量。 - Using limestone and aluminum oxide as raw materials, the batch ingredient and burning temperature on pure calcium aluminate cement properties are discussed.
以石灰石和工业氧化铝为原料研究了煅烧温度及配料组成对纯铝酸钙水泥性能的影响。 - The paper discusses the computing method and computing process of theoretical burning temperature.
探讨了计算理论燃烧温度的方法及推导过程。 - In gas-fired flame mainly was NO. The burning temperature was the main reason of the production of NO. The air coefficient effected the production of NOx by changing burning temperature.
燃气火焰中热力型NOx以NO为主，燃烧温度对NO生成起决定作用，空气系数也主要通过改变燃烧温度影响NOx生成。 - Total K had light undulation under low burning temperature, but the differences under different temperatures were not significant;
土壤全钾含量在低温灼烧阶段有轻微波动，但不同灼烧温度下全钾含量的方差分析差异不显著； - Choosing the reasonable burners integrated with air preheater the theoretic burning temperature of the fuel is raised, that is not only satisfying the technical requirements but also recovering afterheat and saving fuel.
选择合理的燃烧装置，结合预热助燃空气的办法，提高了燃料的理论燃烧温度，满足工艺的要求，同时也回收了热量，节约了燃料。 - So, Increasing the content of C3S in clinker without rising the burning temperature, or even lower the burning temperature seems to be one of the key questions in producing high C3S clinker.
所以，在提高熟料中C3S含量的同时，而不提高熟料的烧成温度，更或者使烧成温度有所降低成为了高C3S熟料制备的关键问题之一。 - The burning temperature mainly depends on the melting point of the siliceous material.
烧成温度主要决定于所用硅质原料本身熔点的高低。 - We classified the heavy metals according to its features and occurrence, and studied the effect that the burning temperature, burning atmosphere and burning time impacted on the volatilization of heavy metals.
考察燃煤重金属元素的挥发析出特性：根据重金属元素的自身特性和赋存状态，对重金属进行了有机分类：并且研究了燃烧温度、燃烧气氛、燃烧时间等因素对重金属挥发性的影响。 - Theoretical burning temperature of methanol, maximum available energy, heat effeciency and heat load of flame rings burner are calculated.
本文计算了CH3OH的理论燃烧温度，喷火圈燃烧器的最大可用能、热效率和热负荷。 - As far as luminescent glaze melts, burning temperature can be lower and burning period can be short.
在确保发光釉熔融的条件下，釉烧温度愈低，烧成周期愈短，发光陶瓷的发光性能愈好。 - Rased on the indoor combustion experiment in muffle, analyze and test the content of trace elements in the burnt products of lignite, fat-coal and anthracite in different burning temperature, and the distributing feature trace elements are analyzed in this paper.
在进行煤的室内静态燃烧实验的基础上，分析测试了褐煤、肥煤和无烟煤在不同燃烧温度下获取的燃烧产物的微量元素含量，计算了微量元素分布、分配特征； - Heat decomposition temperature and initial burning temperature of SBS modified asphalt can be risen by adding compound flame-retarder.
复合阻燃剂的加入可提高改性沥青的热分解温度和开始燃烧温度。 - The significance in increasing theoretical hot stove burning temperature by blast furnace gas enriching and separating was expounded in this paper.
论述了高炉煤气富化分离对提高热风炉理论燃烧温度的重要意义。 - This paper elucidates the relationship among the MgO's burning temperature, burning time with MgO's rate of hydration, rate of swelling, and swelling capacity.
本文阐述了氧化镁（MgO）的煅烧温度、煅烧时间与MgO产生的水化速率、膨胀速率和膨胀量等之间的关系。 - And a mathematical model was put forward, with which the burning temperature in rotary kiln can be exactly calculated.
通过对回转窑煅烧过程中相关气体和固体的比热进行回归计算，建立和引用与温度相关的数学模型，提高了模拟计算的精确度。 - The results show that the increment of oxidizer inlet expansion is favorable for efficiency and stabilization of the motor, and the increase of length of the afterburning chamber can raise the average burning temperature and improve the combustion efficiency.
结果表明，增加氧化剂入口突扩段有利于发动机稳定工作和充分燃烧，增加补燃室长度可以提高发动机平均燃烧温度，使燃烧更加充分。 - The study indicate that the C/ H, burning temperature and burning pressure of the organics rich in carbon influence the productivity, the particle diameter distribution and the appearance of the carbon black remarkably.
研究结果表明，富碳有机物的C／H、燃烧温度和压力对炭黑的生成率、粒径区间、表观形貌等有着较大的影响。 - Using burnability index to control the burning temperature of rotary kiln
用生料易烧性指数控制回转窑煅烧温度 - For diffusion burner, burning temperature is lowest, attenuation of velocity is quick.
扩散式燃烧器燃烧温度最低，速度衰减快。 - Raw meal with high saturation factor and high burning temperature are beneficial to the strength.
高饱和比配料与高温煅烧对强度有利。 - Improvements in engine manufacturing technology have gradually increased the thermal efficiencies of engines as well as the burning temperature and pressure of fuels within the cylinders. And this makes the engine bear higher heat load and mechanical load than before.
发动机制造技术的进步，使发动机功率和热效率提高的同时，也使气缸内的燃烧温度和压力越来越高，这必然使发动机承受更高的热负荷和更大的机械负荷。 - The thermal calculation model was established, the burning temperature formula was proposed, and the main operating parameters on the stability of burning was studied from the perspective of the critical heat value.
建立了热平衡计算模型，得到焚烧温度公式，从临界热值的角度研究主要运行参数对焚烧稳定性的影响。 - In the same time, using the infrared thermometer to test its burning temperature, and analysis the connection of burning temperature and radiation intensity.
同时，利用红外测温仪测试它们的燃烧温度。并对药柱燃烧温度同辐射亮度之间的关系进行了分析。